New Bezel Insert For OMEGA PLANET OCEAN Watch Dial Replacement Part Orange/Black

Omega Planet Ocean Replacement Watch Bezel Insert

Condition - New

Small Size - 40.4mm X 32.7mm

Large Size - 41.2mm X 33.6mm

Orange Colour - Black Lettering

Black Colour - Silver Lettering

Material - Aluminium

Thickness - 0.5mm

If you would like to purchase one of bezel inserts then the below information will be useful.

Pearl Checking – Please check the pearl (at 12 O’clock) is secure after fitting. On all inserts the pearls are separate from the insert so can come off. We check that the pearl is supplied when they are dispatched but it's your responsibility to make sure the pearl is in place properly. You can use household glue to secure them in place (NOT superglue).

Removal - Use a sharp blade to gently lift the old insert slightly. Then work your way round the bezel lifting a bit at a time. Once you have removed the old one clean the area to remove any of the glue/adhesive that's left. Nail polish remover is good for this.

Fitting - These inserts are NOT pressure fit. Most of our inserts have the adhesive already on the bezel in the form of very strong sticky back plastic (if not then you can use household glue - NOT superglue). Take the backing off (this is the tricky part) and align the insert to 12 O'clock. Once it is aligned you just place a cloth over the insert and press down to make sure it is stuck down correctly. Clean off any adhesive that might be on the bezel then that's it, finished.